Materials & specs 5 min read

    The ten-minute-a-year maintenance that doubles hardware life

    Nearly every hardware failure we're called out to could have been prevented by ten minutes of maintenance a year. Here's the whole routine, and the short list of products that quietly cause damage.

    The short answer

    Twice a year, clean the frames and gaskets with mild soapy water; once a year, lubricate hinges, locking points and cylinders with a light machine oil or dedicated lock lubricant. Never use solvents, abrasive creams or WD-40 on a cylinder.

    Twice a year — clean

    Frames and sills: warm water with a little washing-up liquid and a soft cloth. Rinse and dry.

    Gaskets: wipe the rubber seals with the same solution and let them dry. Grit trapped in a gasket is what tears it, and a torn gasket is a draught.

    Drainage slots: the small slots at the bottom of the outer frame let water out. Clear them with a soft brush — blocked slots cause water to pool and eventually track inwards.

    Once a year — lubricate

    Hinges: a drop of light machine oil on each pivot, then open and close a few times.

    Multi-point locking: lift the handle to expose the hooks and rollers, apply a light oil to each moving part, wipe off the excess.

    Cylinder: use a dedicated lock lubricant or a graphite product. Not WD-40 — it displaces existing lubricant and attracts dust, and it's a common cause of a cylinder that seizes a year later.

    • Hinges — light machine oil, all pivots
    • Locking hooks and rollers — light oil, wipe excess
    • Cylinder — dedicated lock lubricant only
    • Handles and letterplate springs — a drop on the pivot
    • Check every key turns without force

    Never use these

    Abrasive cream cleaners and scouring pads — they scratch the surface of PVCu permanently and the scratches then hold dirt.

    Solvent-based cleaners, acetone and paint thinners — they attack the surface and any foiled finish.

    Bleach on gaskets — it degrades the rubber and shortens seal life.

    Pressure washers close to the frame — they force water past the gaskets and can blow out sealant.

    Signs to act on early

    A door needing a lift or a shove to lock means the keeps have shifted or the door has settled. It's a fifteen-minute adjustment now and a broken gearbox if you keep forcing it.

    A window that whistles in wind is a gasket or hinge issue and is far cheaper to fix than to ignore through a winter.

    Something already sticking or draughting?

    Most adjustments are quick. Tell us the symptom and we'll tell you whether it's a fix or a replacement.

    Materials & specs — common questions

    Get a Free Written Quote

    Tell us what you need and our Leicester team will provide a clear, no-pressure quote.

    ✓ 40+ years local ✓ 10-year insurance-backed guarantee ✓ Free no-pressure survey